Switching out of offline protection mode
Switch only if you chose offline protection mode for evaluation or transition purposes when you first set up your FortiWeb appliance, and now want to transition to a full deployment.
To switch the operation mode
1. Back up your configuration. See
“Backups”.
| Back up your system before changing the operation mode. Changing modes deletes policies not applicable to the new mode, static routes, and V-zone IP addresses. You may also need to re-cable your network topology to suit the operation mode. |
2. Disconnect all cables from the physical ports except the cable to your management computer.
3. Reconfigure the network interfaces with the IP addresses and routes that they will need in their new topology.
6. Go to
Router > Static > Static Route. If your static routes were erased, re-create them. See
“Adding a gateway”.
7. Go to
System > Network > Interface. If your VLAN
configurations were removed, re-create them. If you chose one of the transparent modes, consider creating a v-zone bridge instead of VLANs. See
“Configuring a bridge (V-zone)”.
10. Watch the monitors on the dashboard to make sure traffic is flowing through your appliance in the new mode.
11. Since there are many possible configuration changes when switching modes, including additional available protections, don’t forget to retest. Prior testing is no longer applicable.