This command configures, but does not execute, the synchronization. To do this, use the web UI. This command works only when administrative domains (ADOMs) are disabled. |
Variable | Description | Default |
ip <remote-fortiweb_ipv4> | Type the IP address of the remote FortiWeb appliance that you want to synchronize with the local FortiWeb appliance. | 0.0.0.0 |
password <password_str> | Type the administrator password for the remote FortiWeb appliance. The maximum length is 63 characters. | No default. |
sync-type {full‑sync | partial-sync} | Select one of the synchronization types: • full-sync — Update the entire configuration of the peer FortiWeb appliance except its network interfaces and administration configuration. Note: This option has no effect if the FortiWeb appliance is operating in reverse proxy mode. See “config system settings”. • partial-sync — Update the configuration of the peer FortiWeb appliance, with the exception of: config system ... config router ... config server-policy ... commands for health, server-pool, vserver, service, and http-content-routing-policy config server-policy policy (completely replaces the peer’s policy) | partial-sync |
server-port <port_int> | Type the port number of the remote (peer) FortiWeb appliance that is used to connect to the local appliance for configuration synchronization. The valid range is from 1 to 65,535. Caution: The port number used with this command must be different than the port number used with config system global command or the submitting operation will fail. | 8333 |