restore image

execute : restore image

restore image

Use this command to install firmware on the primary partition and reboot.


	Back up the configuration before installing new firmware. Installing new firmware can change default settings and reset settings that are incompatible with the new version. For backup commands, see “execute backup full-config” and “execute backup cli-config”.

Unlike installing firmware via TFTP during a boot interrupt, installing firmware using this command will attempt to preserve settings and files, and not necessarily restore the FortiWeb appliance to its firmware/factory default configuration.

To use this command, your administrator account’s access control profile must have either w or rw permission to the mntgrp area. For more information, see “Permissions”.

Syntax

execute restore image ftp <filename_str> <ftp_ipv4>

execute restore image tftp <filename_str> <tftp_ipv4>


Variable	Description	Default
<filename_str>	Type the name of the firmware image file.	No default.
<ftp_ipv4>	Type the IP address of the TFTP server.	No default.
<tftp_ipv4>	Type the IP address of the FTP server.	No default.

Example

This example installs a firmware file named firmware.out from the TFTP server, 192.168.1.23, to the FortiWeb appliance.

execute restore image tftp firmware.out 192.168.1.23

The FortiWeb appliance downloads the firmware file, installs it, and reboots.