Configuring the WCCP client (WCCP_client)
Use the following steps to configure WCCP_client as the WCCP client for the example network. The example steps only describe the WCCP-related configuration.
To configure WCCP_client as a WCCP client
1. Configure WCCP_client to operate as a WCCP client.
config system settings
set wccp-cache-engine enable
end
| You cannot enter the wccp-cache-engine enable command if you have already added a WCCP service group. When you enter this command an interface named w.<vdom_name> is added to the FortiGate configuration (for example w.root). All traffic redirected from a WCCP router is considered to be received at this interface of the FortiGate unit operating as a WCCP client. A default route to this interface with lowest priority is added. |
2 Enable WCCP on the port1 interface.
config system interface
edit port1
set wccp enable
end
3 Add a WCCP service group with service ID 0.
config system wccp
edit 0
set cache-id 10.51.101.10
set router-list 10.51.101.100
end