Performing a factory reset of SPP settings

In some situations, you might want to both reset thresholds for a particular SPP and clear its traffic history. For example:

• You have changed the SPP policy network address configuration.
• You have deployed a new server or service in the SPP network. Therefore, you want the appliance to recalculate the baseline.
• You are conducting a demonstration or test, or you are troubleshooting an issue.

Table 53 summarizes “factory reset” options.

Before you begin:

• You must have Read-Write permission for Protection Profile settings.

To perform a factory reset of SPP threshold settings and traffic history:

1. Go to Protection Profiles > Factory Reset > Factory Reset.
2. Select the SPP you want to reset from the drop-down list.
3. Select the reset check box.
4. Save the configuration.

To configure with the CLI, use a command sequence similar to the following: config spp edit <entry_index> config ddos spp factoryreset set reset enable end