This section includes the following information:
CLI commands:
|
Always properly shut down the system before turning off the power switch or unplugging it. This causes it to finish writing any buffered data, and to correctly spin down and park the hard disks.
Do not unplug or switch off the FortiDDoS appliance without first halting the operating system. Failure to do so could cause data loss and hardware problems. |
The system does not emit disk activity noise when shutdown is complete.
CLI commands:
|
Power supplies and switches vary by hardware model. On some, you press the power button; on others, you flip the switch to either the off (O) or on (I) position.
Table 90 summarizes “factory reset” options.
Task | Menu |
---|---|
Reset the threshold configuration for an SPP. | Protection Profiles > Thresholds > Factory Defaults |
Reset the threshold configuration and clear traffic history for an SPP. | Protection Profiles > Factory Reset > Factory Reset |
Reset the system to its factory state. All SPPs, statistics, and logs will be deleted. | See below. |
Use the command based on the following: