How to set up your FortiWeb : Configuring the network settings
 
Configuring the network settings
When shipped, each of the FortiWeb appliance’s physical network adapter ports (or, for FortiWeb‑VM, vNICs) has a default IP address and netmask. If these IP addresses and netmasks are not compatible with the design of your unique network, you must configure them.
Table 10: Default IP addresses and netmasks
Network Interface*
IPv4 Address/Netmask
IPv6 Address/Netmask
port1
192.168.1.99/24
::/0
port2
0.0.0.0/0
::/0
port3
0.0.0.0/0
::/0
port4
0.0.0.0/0
::/0
* The number of network interfaces varies by model.
You also must configure FortiWeb with the IP address of your DNS servers and gateway router.
You can use either the web UI or the CLI to configure these basic network settings.
 
If you are installing a FortiWeb-VM virtual appliance, and you followed the instructions in the FortiWeb-VM Install Guide, you have already configured some of the settings for port1. To fully configure all of the network interfaces, you must complete this chapter.