Advanced/optional system settings > Fail-to-wire for power loss/reboots

Fail-to-wire for power loss/reboots

If your appliance’s hardware model, network cabling, and configuration supports it, you can configure fail-to-wire/bypass behavior. This allows traffic to pass through unfiltered between 2 ports (a link pair) while the FortiWeb appliance is shut down, rebooting, or has unexpectedly lost power such as due to being accidentally unplugged or PSU failure.

Fail-open is supported only:

  • when the operation mode is true transparent proxy, transparent inspection, or WCCP
  • in standalone mode (not HA)
  • for a bridge (V‑zone) between ports wired to a CP7 processor or other hardware which provides support for fail-to-wire
    • FortiWeb 1000C: port3 + port4
    • FortiWeb 3000C/D: port5 + port6
    • FortiWeb 3000E/4000E: port9 + port10, port11 + port12, port13 + port14, or port15 + port16
    • FortiWeb 4000C/D: port5 + port6 or port7 + port8
    • FortiWeb 3000CFsx/DFsx:    port5 + port6 or port7 + port8

FortiWeb-400B/400C, FortiWeb HA clusters, and ports not wired to a CP7/fail-open chip do not support fail-to-wire.

 

In the case of HA, don’t use fail-open — instead, use a standby HA appliance to provide full fault tolerance.

Bypass results in degraded security while FortiWeb is shut down, and therefore HA is usually a better solution: it ensures that degraded security does not occur if one of the appliances is shut down. If it is possible that both of your HA FortiWeb appliance could simultaneously lose power, you can add an external bypass device such as FortiBridge.

Fail-to-wire may be useful if you are required by contract to provide uninterrupted connectivity, or if you consider connectivity interruption to be a greater risk than being open to attack during the power interruption.

Aside from the usual network topology requirements for the transparent operation modes, there are no special requirements for fail-to-wire. During setup, after setting the operation mode, you will simply go to System > Network > Fail-open then select either:

See also