Testing a Rule

After creating or editing a rule, you should test it to see if it works as expected, before activating.

Note: You can perform rule testing only on the super global organization and not within the local organization.

Complete these steps to test a rule:

1. Go to RESOURCES > Rules, and deactivate the rule to test.
   Note: If you cannot deactivate a rule for testing, you can clone an inactive version of it.
2. In the Set Activation Scope dialog box, deselect the Activation Status for New Org and all of the organizations under Activation Status for This Rule.
3. Click Save to close the Set Activation Scope dialog box.
4. Select the rule, and click Test. 
   This opens the Rule Debug Events dialog box.
5. Enter a Reporting IP where the synthetic event should originate from.
   If the rule you're testing specifies that the Reporting IP should be a member of a group, you should make sure that the Reporting IP you enter here is in that group.
6. Under Raw Event, enter the raw event log text that contains the triggering conditions for the rule. 
7. Under Pause, enter the number of seconds before the next test event will be sent, and click + under Action to enter additional test events.
   Create as many events as necessary to trigger the rule conditions. 
8. Click Test Rule.
   If the test succeeds you are now ready to activate the rule.