Editing Performance Monitors

After the discovery is complete, FortiSIEM starts monitoring successfully discovered devices for performance, availability and change. The following section describes the procedure to see the status of these performance monitoring jobs and edit them.

Viewing performance monitoring jobs

  1. Go to ADMIN > Setup > Monitor Performance tab.
  2. To check the Device Health details, select the device from the list and click the drop-down near the device name.
  3. To check the errors during the monitoring job, select the device and click More > Errors.
  4. To export a Performance Monitor, select the device and click More > Export Monitors.
  5. To generate a Performance Monitoring report for any device(s), select the device and click More > Report.

Enabling/Disabling performance monitoring jobs

Follow the procedure below to enable/disable performance monitoring at a device level – all jobs will be enabled/disabled:

  1. Go to ADMIN > Setup > Monitor Performance tab.
  2. Select the device from the list.
  3. Select Enabled check-box to enable and select again to disable.
  4. Click Apply.

Modifying performance monitoring jobs

Follow the procedure below to enable/disable a specific performance monitoring job for a device:

  1. Change the Scope to Local and go to ADMIN > Setup > Monitor Performance tab.
  2. Select the device from the list.
  3. Click More and select the required option:
    • Edit System Monitors to select the Protocols and click Save.
    • Edit App Monitors to select the Protocols and click Save.
  4. Click Save.
  5. Click Apply.

Another way to enable/disable a specific job or tune monitoring intervals for specific jobs for all devices:

  1. Go to ADMIN > Setup > Monitor Performance tab.
  2. Click More > Edit Intervals.
  3. In the Set Intervals pop-up:
    • Choose the Monitor on the left panel.
    • Choose the device on the middle panel.
    • Click >> to move the chosen jobs on the chosen devices to the right panel.
    • Choose the new polling interval or choose Disabled.
    • Click Save.
  4. Click Apply.