• All Files

Home

Editing Performance Monitors

After the discovery is complete, FortiSIEM starts monitoring successfully discovered devices for performance, availability and change. The following section describes the procedure to see the status of these performance monitoring jobs and edit them.

• Viewing performance monitoring jobs
• Modifying performance monitoring jobs

Viewing performance monitoring jobs

1. Go to ADMIN > Setup > Pull Events tab.
2. See the listed jobs:
   • Enabled – the job is enabled at a device level.
   • Device name – name of the device in CMDB.
   • Access IP – IP address with which FortiSIEM accesses this device.
   • Device Type – the device type in CMDB.
   • Organization – the organization to which this device belongs (for a multi-tenant FortiSIEM install).
   • Method – the event pulling method – format - credential name (Access Protocol).
   • Maintenance – indicates if this device is in maintenance or not.

Modifying performance monitoring jobs

Follow the procedure below to enable/disable performance monitoring at a device level – all jobs will be enabled/disabled:

1. Go to ADMIN > Setup > Monitor Performance tab.
2. Select the device from the list.
3. Select Enabled check-box to enable and select again to disable.
4. Click Apply

Follow the procedure below to enable/disable a specific performance monitoring job for a device:

1. Go to ADMIN > Setup > Monitor Performance tab.
2. Select the device from the list.
3. Click More > Edit System Monitors or Edit Performance Monitors.
4. Check the specific job to enable/disable.
5. Click Apply.

Another way to enable/disable a specific job or tune monitoring intervals for specific jobs for all devices:

1. Go to ADMIN > Setup > Monitor Performance tab.
2. Click More > Edit Intervals
3. In the Set Intervals pop-up:
   • Choose the Monitor on the left panel.
   • Choose the device on the middle panel.
   • Click >> to move the chosen jobs on the chosen devices to the right panel.
   • Choose the new polling interval or choose disabled.
   • Click Save.
   • Click Apply.