How the SIP ALG creates RTP pinholes
The SIP ALG requires the following information to create a pinhole. The SIP ALG finds this information in SIP messages and some is provided by the SIP ALG:
|Protocol||UDP (Extracted from SIP messages by the SIP ALG.)|
|Destination IP||The SIP ALG extracts the destination IP address from the c= line in the SDP profile. The c= line can appear in either the session or media part of the SDP profile. The SIP ALG uses the IP address in the c= line of the media part of the SDP profile first. If the media part does not contain a c= line, the SIP ALG checks the c= line in the session part of the SDP profile. If the session part of the profile doesn’t contain a c= line the packet is dropped. Pinholes for RTP and RTCP sessions share the same destination IP address.|
|Destination port||The SIP ALG extracts the destination port number for RTP from the m= field and adds 1 to this number to get the RTCP port number.|
|Lifetime||The length of time during which the pinhole will be open. When the lifetime ends, the SIP ALG removes the pinhole.|
The SIP ALG keeps RTP pinholes open as long as the SIP session is alive. When the associated SIP session is terminated by the SIP ALG or the SIP phones or servers participating in the call, the RTP pinhole is closed.
The figure below shows a simplified call setup sequence that shows how the SIP ALG opens pinholes. Phone A and Phone B are installed on either side of a FortiGate operating in Transparent mode. Phone A and Phone B are on the same subnet. The FortiGate includes a security policy that accepts SIP sessions from port1 to port2 and from port2 to port1. The FortiGate does not require an RTP security policy, just the SIP policy.
You can see from this diagram that the SDP profile in the INVITE request from Phone A indicates that Phone A is expecting to receive a media stream sent to its IP address using port 4000 for RTP and port 4001 for RTCP. The SIP ALG creates pinhole 1 to allow this media traffic to pass through the FortiGate. Pinhole 1 is opened on the Port2 interface and will accept media traffic sent from Phone B to Phone A.
When Phone B receives the INVITE request from Phone A, Phone B will know to send media streams to Phone A using destination IP address 10.31.101.20 and ports 4000 and 4001. The 200 OK response sent from Phone B indicates that Phone B is expecting to receive a media stream sent to its IP address using ports 8000 and 8001. The SIP ALG creates pinhole 2 to allow this media traffic to pass through the FortiGate. Pinhole 2 is opened on the Port1 interface and will accept media traffic sent from Phone A to Phone B.
SIP call setup with a FortiGate in Transparent mode