On FortiGate model 30D, web-based manager configuration of FortiAP Profiles is disabled by default. To enable AP profiles, enter the following CLI commands: config system global set gui-ap-profile enable end |
Mode | Select the type of mode. • Disable – radio disabled • Access Point – the platform is an access point |
Spectrum Analysis | Select to enable monitoring other APs in the background, even while operating as an AP. This is needed for the Rogue AP detection feature. By default, spectrum analsis is disabled. See “Wireless network monitoring”. |
WIDS Profile | Optionally, select a Wireless Intrusion Detection (WIDS) profile. See “Wireless IDS”. |
Radio Resource Provision | Select to enable the radio resource provision feature. This feature measures utilization and interference on the available channels and selects the clearest channel at each access point. The measurement can be repeated periodically to respond to changing conditions. |
Client Load Balancing | Select Frequency Handoff or AP Handoff as needed. See “Wireless client load balancing for high-density deployments”. |
Band | Select the wireless protocols that you want to support. The available choices depend on the radio’s capabilities. Where multiple protocols are supported, the letter suffixes are combined: “802.11bg” means 802.11b and 802.11g. For 802.11n, 802.11n_2.4G indicates 2.4GHz, 802.11n_5G indicates 5GHz. Note that on two-radio units such as the FortiAP-220B it is not possible to put both radios on the same band. |
Select Channel Width | Select to enable 20MHz or 40MHz channel width for 802.11n-5G. |
Short Guard Interval | Select to enable the short guard interval for 802.11n_5G with 40MHz channel width. |
Channel | Select the channel or channels to include. The available channels depend on which IEEE wireless protocol you selected in Band. By default, all available channels are enabled. |
Auto Tx Power Control | Optionally, enable automatic adjustment of transmit power, specifying minimum and maximum power levels. |
TX Power | By default, the TX power is set to 100% of the maximum power permitted in your region. To change the level, drag the slider. |
SSID | Choose the SSIDs (WiFi networks) that APs using this profile will carry. |