Configuring stand alone mode
Configuring stand alone mode is a matter of configuring the modem information and the dialing mode. The dial mode is either Always Connect or Dial on demand. Selecting Always Connect ensures that once the modem has connected, it remains connected to the ISP. Selecting Dial on Demand, the modem only calls the ISP if packets are routed to the modem interface. Once sent, the modem will disconnect after a specified amount of time.
To configure standalone mode as needed - web-based manager
1. Go to System > Network > Modem.
2. Select the Mode of Standalone.
3. Select the Dial Mode of Dial on Demand.
4. Select the number of redials the modem attempts if connection fails to 5.
5. Select Apply.
To configure standalone mode as needed- CLI
config system modem
set status enable
set mode standalone
set auto-dial enable
set redial 5
end
See Also