Default static route for a VDOM
The routing you define applies only to network traffic entering non-ssl interfaces belonging to this VDOM. Set the administrative distance high enough, typically 20, so that automatically configured routes will be preferred to the default.
In the following procedure, it is assumed that a VDOM called “Client2” exists. The procedure will create a default static route for this VDOM. The route has a destination IP of 0.0.0.0, on the port3 interface. It has a gateway of 10.10.10.1, and an administrative distance of 20.
The values used in this procedure are very standard, and this procedure should be part of configuring all VDOMs.
To add a default static route for a VDOM - web-based manager
1. In Virtual Domains, select the client2 VDOM.
2. Go to System > Network > Routing.
3. Select Create New.
4. Enter the following information and select OK:
Destination IP/Mask | 0.0.0.0/0.0.0.0 |
Device | port2 |
Gateway | 10.10.10.1 |
Distance | 20 |
To add a default static route for a VDOM - CLI
config vdom
edit client2
config router static
edit 4
set device port2
set dst 0.0.0.0 0.0.0.0
set gateway 10.10.10.1
set distance 20
end
end