Display SIP rate-limit data
You can use the diagnose sys sip-proxy meters command to display SIP rate limiting data.
For the following command output rate 1 shows that the current (over last second) measured rate for INVITE/ACK and BYTE was 1 per second, the peak 1 shows that the peak rate recorded is 1 per second, the max 0 shows that there is no maximum limit set, the count 18 indicates that 18 messages were received and drop 0 indicates that none were dropped due to being over the limit.
diag sys sip-proxy meters
sip
sip vd: 0
sip policy: 1
sip identity-policy: 0
sip policy-type: IPv4
sip profile-group:
sip dialogs: 18
sip dialog-limit: 0
sip UNKNOWN: rate 0 peak 0 max 0 count 0 drop 0
sip ACK: rate 1 peak 1 max 0 count 18 drop 0
sip BYE: rate 1 peak 1 max 0 count 18 drop 0
sip CANCEL: rate 0 peak 0 max 0 count 0 drop 0
sip INFO: rate 0 peak 0 max 0 count 0 drop 0
sip INVITE: rate 1 peak 1 max 0 count 18 drop 0
sip MESSAGE: rate 0 peak 0 max 0 count 0 drop 0
sip NOTIFY: rate 0 peak 0 max 0 count 0 drop 0
sip OPTIONS: rate 0 peak 0 max 0 count 0 drop 0
sip PRACK: rate 0 peak 0 max 0 count 0 drop 0
sip PUBLISH: rate 0 peak 0 max 0 count 0 drop 0
sip REFER: rate 0 peak 0 max 0 count 0 drop 0
sip REGISTER: rate 0 peak 0 max 0 count 0 drop 0
sip SUBSCRIBE: rate 0 peak 0 max 0 count 0 drop 0
sip UPDATE: rate 0 peak 0 max 0 count 0 drop 0
sip PING: rate 0 peak 0 max 0 count 0 drop 0
sip YAHOOREF: rate 0 peak 0 max 0 count 0 drop 0