Defining the multicast routing
In this example, the following command syntax is used to define multicast routing. The example uses a Boot Start Router (BSR) to find the Rendezvous Points (RPs) instead of using static RPs. Under interface configuration, the loopback interface lo0 must join the 236.1.1.1 group (source).
config router multicast
config interface
edit port6
set pim-mode sparse-mode
next
edit port1
set pim-mode sparse-mode
next
edit lo0
set pim-mode sparse-mode
set rp-candidate enable
config join-group
edit 236.1.1.1
next
end
set rp-candidate-priority 1
next
end
set multicast-routing enable
config pim-sm-global
set bsr-allow-quick-refresh enable
set bsr-candidate enable
set bsr-interface lo0
set bsr-priority 200
end
end