Testing traffic from VLAN_100 to VLAN_200
In this example, a route is traced between two internal networks. The route target is a host on VLAN_200. The Windows traceroute command tracert is used.
From VLAN_100, access a Windows command prompt and enter this command:
C:\>tracert 10.12.0.2
Tracing route to 10.12.0.2 over a maximum of 30 hops:
1 <10 ms <10 ms <10 ms 10.100.0.1
2 <10 ms <10 ms <10 ms 10.12.0.2
Trace complete.
You can repeat this for different routes in the topology. In each case the IP addresses will be the gateway for the starting VLAN, and the end point at the ending VLAN.