Configure FortiGate A IPsec settings
The phase 1 configuration creates a virtual IPsec interface on port 2 and sets the remote gateway to the public IP address FortiGate B. This configuration is the same as for an IPv4 route-based VPN, except that ip-version is set to 6 and the remote-gw6 keyword is used to specify an IPv6 remote gateway address.
config vpn ipsec phase1-interface
edit toB
set ip-version 6
set interface port2
set remote-gw6 fec0:0000:0000:0003:209:0fff:fe83:25c7
set dpd enable
set psksecret maryhadalittlelamb
set proposal 3des-md5 3des-sha1
end
By default, phase 2 selectors are set to accept all subnet addresses for source and destination. The default setting for src-addr-type and dst-addr-type is subnet. The IPv6 equivalent is subnet6. The default subnet addresses are 0.0.0.0/0 for IPv4, ::/0 for IPv6.
config vpn ipsec phase2-interface
edit toB2
set phase1name toB
set proposal 3des-md5 3des-sha1
set pfs enable
set replay enable
set src-addr-type subnet6
set dst-addr-type subnet6
end