Connecting to the FortiMail web UI for the first time
To use the web UI for the initial configuration, you must have:
• a computer with an Ethernet port
• a supported web browser (Microsoft Internet Explorer 11, Firefox 21 to 26, Safari 5 to 7, and Chrome 26 to 35)
• Adobe Flash Player 9 or higher plug-in to display statistic charts
• a crossover Ethernet cable
Table 3: Default settings for connecting to the web UI
Network Interface | port1 |
URL | |
Administrator Account | admin |
Password | (none) |
To connect to the web UI
1. Configure the management computer to be on the same subnet as the port 1 interface of the FortiMail unit.
For example, in Microsoft Windows 7, from the Windows Start menu, go to Control Panel > Network and Sharing Center > Change Adapter Settings > Local Area Connection Properties > Internet Protocol Version 4 (TCP/IPv4) Properties and change the management computer IP address to 192.168.1.2 and the netmask to 255.255.255.0.
2. Using the Ethernet cable, connect your computer’s Ethernet port to the FortiMail unit’s port1.
| If you are connecting to FortiMail-VM with a trial license or to a LENC version of FortiMail, you may not be able to see the logon page due to an SSL cipher error during the connection. In this case, you must configure your browser to accept low encryption.
For example, in Mozilla Firefox, if you receive this error message:
ssl_error_no_cypher_overlap
you may need to enter about:config in the URL bar, then set
security.ssl3.rsa.rc4_40_md5 to true. |
To support HTTPS authentication, the FortiMail unit ships with a self-signed security certificate, which it presents to clients whenever they initiate an HTTPS connection to the FortiMail unit. When you connect, depending on your web browser and prior access of the FortiMail unit, your browser might display two security warnings related to this certificate:
• The certificate is not automatically trusted because it is self-signed, rather than being signed by a valid certificate authority (CA). Self-signed certificates cannot be verified with a proper CA, and therefore might be fraudulent. You must manually indicate whether or not to trust the certificate.
• The certificate might belong to another web site. The common name (CN) field in the certificate, which usually contains the host name of the web site, does not exactly match the URL you requested. This could indicate server identity theft, but could also simply indicate that the certificate contains a domain name while you have entered an IP address. You must manually indicate whether this mismatch is normal or not.
Both warnings are normal for the default certificate.
4. Verify and accept the certificate, either permanently (the web browser will not display the self-signing warning again) or temporarily. You cannot log in until you accept the certificate.
For details on accepting the certificate, see the documentation for your web browser.
The Login dialog appears.
5. In the Name field, type admin, then select Login. (In its default state, there is no password for this account.)
Login credentials entered are encrypted before they are sent to the FortiMail unit. If your login is successful, the web UI appears.
To log out from the web UI
• Click the Log Out button at the upper right corner of the web UI.