wireless-controller : timers
 
timers
Use this command to alter global timers for physical access points, also known as WLAN Termination Points (WTPs) configured using Control And Provisioning of Wireless Access Points (CAPWAP) protocol.
Syntax
config wireless-controller timers
set client-idle-timeout <seconds>
set darrp-optimize <seconds_int>
set darrp-wtp-tune <seconds_int>
set discovery-interval <seconds>
set echo-interval <seconds>
set fake-ap-log <int>
set rogue-ap-log <int>
set sta-capability-interval <int>
set sta-stats-interval <int>
end
 
Variable
Description
Default
client-idle-timeout <seconds>
Set the timeout period in seconds for inactive clients.
Range: 20 to 3600, 0 for no timeout.
300
darrp-optimize <seconds_int>
Set the DARRP (Dynamic Automatic Radio Resource Provisioning) optimization interval. Range: 0 to 86 400 seconds.
1800
darrp-wtp-tune <seconds_int>
Set the automatic channel selection interval. Range: 1 to 30 seconds.
3
discovery-interval <seconds>
Set the period between discovery requests. Range 2 to 180 seconds.
5
echo-interval <seconds>
Set the interval before WTP sends Echo Request after joining AC. Range 1 to 600 seconds.
30
fake-ap-log <int>
Set a period, in minutes, for periodic logging of fake APs.
1
rogue-ap-log <int>
Set a period, in minutes, for periodic logging of rogue APs.
0
sta-capability-interval <int>
Set the interval, in seconds, between station capability information reports. Range 1 to 255.
30
sta-stats-interval <int>
Set the interval, in seconds, between station statistics reports. Range 1 to 255.
1