wireless-controller : global
 
global
Use this command to configure global settings for physical access points, also known as WLAN Termination Points (WTPs), configured using Control And Provisioning of Wireless Access Points (CAPWAP) protocol.
Syntax
config wireless-controller global
set data-ethernet-II {enable | disable}
set dhcp-option-code <option_int>
set discovery-mc-addr <ipv4addr>
set local-radio-vdom <vdom_name>
set location <string>
set max-clients <int>
set max-retransmit <int>
set mesh-eth-type <id_int>
set name <string>
set rogue-scan-mac-adjacency <int>
end
 
Variable
Description
Default
data-ethernet-II {enable | disable}
Enable or disable use of Ethernet frame type with 802.3 data tunnel mode.
disable
dhcp-option-code <option_int>
Enter DHCP option code. This is available when ac‑discovery‑type is dhcp.
138
discovery-mc-addr <ipv4addr>
Enter the IP address for AP discovery. This is available when ac‑discovery‑type is multicast.
224.0.1.140
local-radio-vdom <vdom_name>
Select the VDOM to which the FortiWiFi unit’s built-in access point belongs.
root
location <string>
Enter the location of your wireless network.
No default.
max-clients <int>
Enter the maximum number of clients permitted to connect simultaneously. Enter 0 for no limit.
0
max-retransmit <int>
Enter the maximum number of retransmissions for tunnel packet. Range 0 to 64.
3
mesh-eth-type <id_int>
Identifier included in packets. Useful for debugging.
8755
name <string>
Enter a name for your wireless network.
No default.
rogue-scan-mac-adjacency <int>
Enter the maximum numeric difference between an AP’s Ethernet and wireless MAC values to match for rogue detection.
Range: 0-7.
7