system : vdom-sflow
 
vdom-sflow
Use this command to add or change the IP address and UDP port that FortiGate sFlow agents operating on interfaces in a non-management VDOM use to send sFlow datagrams to an sFlow collector.
Syntax
config system sit-tunnel
set collector-ip <collector_ipv4>
set collector-ip <collector_ipv4>
set vdom-sflow {enable | disable}
end
Variable
Description
Default
collector-ip <collector_ipv4>
The IP address of the sFlow collector that sFlow agents added to interfaces in this VDOM should send sFlow datagrams to.
0.0.0.0
collector_port <port_int>
The UDP port number used for sending sFlow datagrams. Change this setting only if required by your sFlow collector or you network configuration.
6343
vdom-sflow {enable | disable}
Enable configuring sFlow settings for the current VDOM.
enable