system : sit-tunnel
 
sit-tunnel
Use this command to tunnel IPv6 traffic over an IPv4 network. The IPv6 interface is configured under config system interface. The command to do the reverse is system ipv6-tunnel.This command is not available in Transparent mode.
Syntax
config system sit-tunnel
edit <tunnel_name>
set destination <tunnel_address>
set interface <name>
set ip6 <address_ipv6>
set source <address_ipv4>
end
Variable
Description
Default
edit <tunnel_name>
Enter a name for the IPv6 tunnel.
No default.
destination <tunnel_address>
The destination IPv4 address for this tunnel.
0.0.0.0
interface <name>
The interface used to send and receive traffic for this tunnel.
No default.
ip6 <address_ipv6>
The IPv6 address for this tunnel.
No default.
source <address_ipv4>
The source IPv4 address for this tunnel.
0.0.0.0