system : probe-response
 
probe-response
Use this command to configure probe responses.
Syntax
config system probe-response
set http-probe {enable | disable}
set http-probe-value <string>
set mode {http-probe | twamp}
set port <port_int>
end
Variable
Description
Default
http-probe {enable | disable}
Enable or disable probe response.
disable
http-probe-value <string>
Enter content of probe response.
OK
mode {http-probe | twamp}
Select either HTTP-probe or Two-Way Active Measurement Protocol (TWAMP) mode.
http-probe
port <port_int>
Enter to port to respond on.
8008