system : ipv6-tunnel
 
ipv6-tunnel
Use this command to tunnel IPv4 traffic over an IPv6 network. The IPv6 interface is configured under config system interface. All subnets between the source and destination addresses must support IPv6.
 
This command is not available in Transparent mode.
Syntax
config system ipv6-tunnel
edit <tunnel_name>
set destination <remote_IPv6_address>
set interface <name>
set source <local_IPv6_address>
end
Variable
Description
Default
edit <tunnel_name>
Enter a name for the IPv6 tunnel.
No default.
destination <remote_IPv6_address>
The destination IPv6 address for this tunnel.
0.0.0.0
interface <name>
The interface used to send and receive traffic for this tunnel.
No default.
source <local_IPv6_address>
The source IPv6 address for this tunnel.
0.0.0.0