How to set up your FortiDB : Configuring the network settings : Configuring network settings using the CLI
 
Configuring network settings using the CLI
For details about each command, see “Overview of commands”.
1. To set the IP address and netmask of a network interface, execute the following command:
config system interface
edit {port1 | port2 | port3 | port4 }
set ip <ip_address> <netmask>
set allowaccess {http https ping ssh telnet}
end
where:
{port1 | port2 | port3 | port4 } is the network interface
<ip_address> is the interface IP address
<netmask> is the interface netmask
{http https ping ssh telnet} specifies the types of administrative access that are permitted
For example:
config system interface
edit port1
set ip 192.168.100.159 255.255.255.0
set allowaccess ping https ssh
end
2. To set the DNS servers, execute the following command. The secondary DNS server is optional:
config system dns
set primary <dns_server_ip>
set secondary <dns_server_ip>
end
where <dns_server_ip> is the IP address of the primary or secondary DNS server.
For example:
config system dns
set primary 65.39.139.52
set secondary 65.39.139.62
end
3. To create a static route, execute the following command:
config system route
edit <seq_num>
set device <port>
set gateway <gateway_ip>
end
where:
<seq_num> is an unused routing sequence number (numbering starts at 1)
<port> is the port for this route
<gateway_ip> is the default gateway IP address for the network
For example:
config system route
edit 1
set device port1
set gateway 172.30.62.254
end