Using the command line interface (CLI) : config : config system route
 
config system route
The config system route command allows you to view or configure static routing table entries.
Syntax
config system route
edit <seq_num>
set device <port>
set dst <dst_ip_mask>
set gateway <gw_ip>
end
where:
Variable
Description
Default
<seq_num>
Enter an unused routing sequence number to create a new route. Enter an existing route number to edit that route.
No default.
device <port>
Enter the port used for this route.
No default.
dst <dst_ip_mask>
Enter the IP address and mask for the destination network.
0.0.0.0 0.0.0.0
gateway <gw_ip>
Enter the default gateway IP address for this network.
0.0.0.0
See also
show system route