The Network tree menu allows you to configure device interfaces, DNS configuration, static routing, and packet capturing.
To view the interface list, go to System > Network > Interfaces.
The following information is shown:
Edit | Select to edit the selected interface. |
Search | Enter a search term in the search text box then select Search to search the interface list. |
Interface | The names of the physical interfaces on your FortiAuthenticator unit. The name, including number, of a physical interface depends on the model. |
IPv4 | The IPv4 address of the interface. |
IPv6 | The IPv6 address of the interface, if applicable. |
Link Status | The link status of the interface. |
Interface Status | The interface name and it’s current link status is displayed. | |
IP Address / Netmask | ||
IPv4 | Enter the IPv4 address and netmask associated with this interface. | |
IPv6 | Enter the IPv6 address associated with this interface. | |
Access Rights | ||
Admin access | Select the allowed administrative service protocols from: Telnet, SSH, HTTPS, HTTP, SNMP. | |
Services | Select the allowed services from: RADIUS Auth, RADIUS Accounting, LDAP, LDAPS, FortiGate FSSO, OCSP, FortiClient FSSO, Hierarchical FSSO, DC/TS Agent FSSO, and Syslog. Note: Syslog is only available if Syslog SSO has been enabled. See General settings. |
To configure DNS settings, go to System > Network > DNS. The primary and secondary nameserver IP addresses can be changed as needed. To apply the changes, select OK.
To view the list of static routes, go to System > Network > Static Routing. Routes can be created, edited, and deleted as required.
The following information is shown:
Create New | Select to create a new static route. |
Delete | Select to delete the selected static route. |
Edit | Select to edit the selected static route. |
IP/Mask | The destination IP address and netmask for this route. |
Gateway | The IP address of the next hop router to which this route directs traffic. |
Device | The device or interface associated with this route. |
Destination IP/mask | Enter the destination IP address and netmask for this route. |
Network interface | Select the network interface that connects to the gateway. |
Gateway | Enter the IP address of the next hop router to which this route directs traffic. |
Comment | Optionally, enter a comment about the route. Make it fun. |
Packets can be captured on configured interfaces by going to System > Network > Packet Capture.
The following information is available:
Edit | Select to edit the packet sniffer on the selected interface. |
Interface | The name of the configured interface for which packets can be captured. For information on configuring an interface, see Interfaces. |
Max packets to capture | The maximum number of packets that can be captured. |
Status | The status of the packet capture process. Allows you to start and stop the capturing process, and download the most recently captured packets. |
To start capturing packets on an interface, select the Start capturing button for that interface. The Status will change to Capturing, and the Stop capturing and download buttons will become available.
If no packets have been captured for that interface, select the Start capturing button.
The file can then be opened using packet analyzer software.
The Edit Packet Sniffer page opens.