|
show
|
Display bootstrap configuration. |
|
set port1-ip <IP/netmask>
|
Enter the IPv4 address and netmask for the port1 interface. Netmask is expected in the /xx format, for example 192.168.0.1/24.
Once this port is configured, you can use the GUI to configure the remaining ports. |
|
set default-gw <IP>
|
Enter the IPv4 address of the default gateway for this interface. This is the default route for this interface. |
|
set date <YYYY-MM-DD>
|
Enter the current date. Valid format is four digit year, 2 digit month, and 2 digit day. For example: set date 2014-08-12 sets the date to August 12th, 2014. |
|
set time <HH:MM:SS>
|
Enter the current time. Valid format is two digits each for hours, minutes, and seconds. 24-hour clock is used. For example 15:10:00 is 3:10pm. |
|
set tz <timezone_index>
|
Enter the current time zone using the time zone index. To see a list of index numbers and their corresponding time zones, enter set tz ?. |
|
set ha-mode {enable | disable}
|
Enable or disable (default) HA mode. |
|
set ha-port <interface>
|
Select a network interface to use for communication between the two cluster members. This interface must not already have an IP address assigned and it cannot be used for authentication services. Both units must use the same interface for HA communication. |
|
set ha-priority {high | low}
|
Set to Low on one unit and High on the other. Normally, the unit with High priority is the master unit. |
|
set ha-password <password>
|
Set the HA password. |
|
set ha-mgmt-ip <IP/netmask>
|
Enter the IP address, with netmask, that this unit uses for HA related communication with the other FortiAuthenticator unit. Format: 1.2.3.4/24.
The two units must have different addresses. Usually, you should assign addresses on the same private subnet. |
|
set ha-mgmt-access {ssh | https | http | telnet}
|
Select the types of administrative access to allow. |
|
set ha-dbg-level <level>
|
Enter the level for HA service debug logs. Range: -4 (fatal) to 4 (debug high). Default: -2 (Warn). |
|
unset <setting>
|
Restore default value. For each set command listed above, there is an unset command, for example unset port1-ip. |