config system tcpdump
This configuration is for the tcpdump utility in the Web UI. The configuration saves TCP dump commands and filter expressions so that they can be re-run from the Web UI. The CLI supports its own tcpdump service. See
execute tcpdump/tcpdump6.
Before you begin:
• You must have read-write permission for system settings.
Syntax
config system tcpdump
edit <No.>
set host <ip&netmask>
set interface <datasource>
set logtraffic {enable|disable}
set max-packet-count <integer>
set port <integer>
set protocol {arp icmp tcp udp}
set specified-protocol {enable|disable}
set status {enable|disable}
end
host | IP address for the interface used for tcpdump. |
interface | Interface to use for tcpdump. |
logtraffic | Enable/disable event logs about using tcpdump. |
max-packet-count | Maximum number of packets to capture. |
port | Port to use for tcpdump. |
protocol | Specify the protocol traffic to capture. |
specified-protocol | Enable/disable the protocol option. |
status | Enable/disable the configuration. |
Example
FortiADC-VM # config system tcpdump
FortiADC-VM (tcpdump) # edit 1
Add new entry '1' for node 2725
FortiADC-VM (1) # set interface port1
FortiADC-VM (1) # set status enable
FortiADC-VM (1) # set max-packet-count 5
FortiADC-VM (1) # end
FortiADC-VM # get system tcpdump 1
interface : port1
status : enable
logtraffic : enable
ipv6 : disable
host :
port :
specified-protocol : disable
max-packet-count : 5