FortiOS 5.6 Online Help Link FortiOS 5.4 Online Help Link FortiOS 5.2 Online Help Link FortiOS 5.0 Online Help Link

Home > Online Help

> Chapter 34 - VoIP Solutions: SIP > SIP debugging > Display SIP rate-limit data

Display SIP rate-limit data

You can use the diagnose sys sip-proxy meters command to display SIP rate limiting data.

For the following command output rate 1 shows that the current (over last second) measured rate for INVITE/ACK and BYTE was 1 per second, the peak 1 shows that the peak rate recorded is 1 per second, the max 0 shows that there is no maximum limit set, the count 18 indicates that 18 messages were received and drop 0 indicates that none were dropped due to being over the limit.

diag sys sip-proxy meters

sip

sip vd: 0

sip policy: 1

sip identity-policy: 0

sip policy-type: IPv4

sip profile-group:

sip dialogs: 18

sip dialog-limit: 0

sip UNKNOWN: rate 0 peak 0 max 0 count 0 drop 0

sip ACK: rate 1 peak 1 max 0 count 18 drop 0

sip BYE: rate 1 peak 1 max 0 count 18 drop 0

sip CANCEL: rate 0 peak 0 max 0 count 0 drop 0

sip INFO: rate 0 peak 0 max 0 count 0 drop 0

sip INVITE: rate 1 peak 1 max 0 count 18 drop 0

sip MESSAGE: rate 0 peak 0 max 0 count 0 drop 0

sip NOTIFY: rate 0 peak 0 max 0 count 0 drop 0

sip OPTIONS: rate 0 peak 0 max 0 count 0 drop 0

sip PRACK: rate 0 peak 0 max 0 count 0 drop 0

sip PUBLISH: rate 0 peak 0 max 0 count 0 drop 0

sip REFER: rate 0 peak 0 max 0 count 0 drop 0

sip REGISTER: rate 0 peak 0 max 0 count 0 drop 0

sip SUBSCRIBE: rate 0 peak 0 max 0 count 0 drop 0

sip UPDATE: rate 0 peak 0 max 0 count 0 drop 0

sip PING: rate 0 peak 0 max 0 count 0 drop 0

sip YAHOOREF: rate 0 peak 0 max 0 count 0 drop 0