Synchronizing IPsec VPN SAs
The FGCP synchronizes IPsec security associations (SAs) between cluster members so that if a failover occurs, the cluster can resume IPsec sessions without having to establish new SAs. The result is improved failover performance because IPsec sessions are not interrupted to establish new SAs. Also, establishing a large number of SAs can reduce cluster performance.
The FGCP implements slightly different synchronization mechanisms for IKEv1 and IKEv2.
Synchronizing SAs for IKEv1
When an SA is synchronized to the subordinate units. the sequence number is set to the maximum sequence number. After a failover, all inbound traffic that connects with the new primary unit and uses the SA will be accepted without needing to re-key. However, first outbound packet to use the SA causes the sequence number to overflow and so causes the new primary unit to re-key the SA.
Please note the following:
- The cluster synchronizes all IPsec SAs.
- IPsec SAs are not synchronized until the IKE process has finished synchronizing the ISAKMP SAs. This is required in for dialup tunnels since it is the synchronizing of the ISAKMP SA that creates the dialup tunnel.
- A dialup interface is created as soon as the phase1 is complete. This ensures that the when HA synchronizes phase1 information the dialup name is included.
- If the IKE process re-starts for any reason it deletes any dialup tunnels that exist. This forces the peer to re-key them.
- IPsec SA deletion happens immediately. Routes associated with a dialup tunnel that is being deleted are cleaned up synchronously as part of the delete, rather than waiting for the SA hard-expiry.
- The FGCP does not sync the IPsec tunnel MTU from the primary unit to the subordinate units. This means that after HA failover if the first packet received by the FortiGate arrives after the HA route has been deleted and before the new route is added and the packet is larger than the default MTU of 1024 then the FortiGate sends back an ICMP fragmentation required. However, as soon as routing is re-established then the MTU will be corrected and traffic will flow.
Synchronizing SAs for IKEv2
Due to the way the IKEv2 protocol is designed the FGCP cannot use exactly the same solution that is used for synchronizing IKEv1 SAs, though it is similar.
For IKEv2, like IKEv1, the FGCP synchronizes IKE and ISAKMP SAs from the primary unit to the subordinate units. However, for IKEv2 the FGCP cannot actually use this IKE SA to send/receive IKE traffic because IKEv2 includes a sequence number in every IKE message and thus it would require synchronizing every message to the subordinate units to keep the sequence numbers on the subordinate units up to date.
Instead, the FGCP synchronizes IKEv2 Message IDs. This Message ID Sync allows IKEv2 to re-negotiate send and receive message ID counters after a failover. By doing this, the established IKE SA can remain up, instead of re-negotiating.
diagnose vpn ike stats command shows statistics for the number of HA messages sent/received for IKEv2. The output of this command includes a number of fields prefixed with
ha that contain high availably related-data. For example: